Skip directly to search Skip directly to A to Z list Skip directly to navigation Skip directly to page options Skip directly to site content

Mining Publication: Determination of In Situ Deformation Modulus for Cemented Rockfill

NOTE: This page is archived for historical purposes and is no longer being maintained or updated. Contact NIOSH Mining if you need an accessible version.

Original creation date: September 2003

Image of publication Determination of In Situ Deformation Modulus for Cemented Rockfill

As part of safety and stability studies at three underground mines in the United States, researchers installed earth pressure cells and embedment strain gauges in cemented rockfill to measure stress and strain changes as mining progressed and the rockfill was loaded. Data from these instruments were used to calculate the in situ modulus of the rockfill for two of the mines. A three-dimensional numerical model of a cemented rockfill cap was validated with data from extensometers anchored in the mine roof and sill; this model was then used to estimate deformation modulus at the third mine because the earth pressure cells and embedment strain gauges recorded negligible changes. Rockfill binder used at these mines ranged from 4 to 8 per cent of the dry components by weight, the water-to-cement ratio was from 0.42 to1.0, and the largest aggregate size in the three mixes ranged from 5 to12 cm (2 to 4.7 in). The range of the calculated in situ deformation modulus values was large, but as expected, it was bracketed by modulus values for cemented tailings and roller-compacted concrete with similar cement contents and water-to-cement ratios.

Authors: DR Tesarik, JB Seymour

Conference Paper - September 2003

NIOSHTIC2 Number: 20024117

Technology Roadmap for Rock Mechanics, 10th Congress, International Society for Rock Mechanics. Vol. 2. Section 33, Johannesburg, South Africa, Sept. 8-10, 2003, S. African Institute of Mining and Metallurgy Symp. Series, 2003 Sep; :1209-1220


TOP