Skip directly to search Skip directly to A to Z list Skip directly to navigation Skip directly to page options Skip directly to site content

Mining Publication: Technology News 472 - Ventilation of a 40-Foot, Two-Pass, Extended Cut

Original creation date: May 1998

Image of publication Technology News 472 - Ventilation of a 40-Foot, Two-Pass, Extended Cut

About one-half of all continuous mining faces in the United States are using extended cutting, i.e., advancing more than 20 ft past the last row of bolts. Most of these extended-cut approvals are for cutting depths of approximately 40 ft. Almost all of the continuous miners on these faces are equipped with machine mounted dust scrubbers and water spray systems for dust control. Little is known about how much ventilation air reaches the box-cut face during various parts of the cutting sequence. This is of particular concern when a 40-ft, two-pass, extended cut is taken, because at the start of the 40-ft slab cut, the continuous miner is located 40 ft from the point of deepest penetration-the face of the 40-ft box cut. NIOSH, Pittsburgh Research Laboratory, undertook a study to evaluate this situation.

Authors: National Institute for Occupational Safety and Health

Technology News - May 1998

NIOSHTIC2 Number: 20000574

Pittsburgh, PA: U.S. Department of Health and Human Services, Public Health Service, Centers for Disease Control and Prevention, NIOSH, Technology News 472, 1998 May; :1-2


TOP