Skip directly to search Skip directly to A to Z list Skip directly to navigation Skip directly to page options Skip directly to site content

Mining Publication: Analysis of Applied Forces and Electromyography of Back and Shoulders Muscles When Performing A Simulated Hand Scaling Task

Original creation date: May 2010

Image of publication Analysis of Applied Forces and Electromyography of Back and Shoulders Muscles When Performing A Simulated Hand Scaling Task

Hand scaling is a physically demanding task responsible for numerous overexertion injuries in underground mining. Scaling requires the miner to use a long pry bar to remove loose rock, reducing the likelihood of rock fall injuries. The experiments described in this article simulated rib scaling (scaling a mine wall) from an elevated bucket to examine force generation and electromyographic responses using two types of scaling bars (steel and fiberglass-reinforced aluminum) at five target heights ranging from floor level to 176 cm. Ten male and six female subjects were tested in separate experiments. Peak and average force applied at the scaling bar tip and normalized electromyography (EMG) of the left and right pairs of the deltoid and erectores spinae muscles were obtained. Work height significantly affected peak prying force during scaling activities with highest force capacity at the lower levels. Bar type did not affect force generation. However, use of the lighter fiberglass bar required significantly more muscle activity to achieve the same force. Results of these studies suggest that miners scale points on the rock face that are below their knees, and reposition the bucket as often as necessary to do so.

Authors: WL Porter, S Gallagher, J Torma-Krajewski

Peer Reviewed Journal Article - May 2010

NIOSHTIC2 Number: 20035982

Appl Ergon 2010 May 41(3):411-416


TOP