Skip directly to search Skip directly to A to Z list Skip directly to page options Skip directly to site content

DISTILLATES, PETROLEUM, solvent-refined light naphthenic

ICSC: 1430

Base oil
Lubricant base oil
Lubricant oil
Mineral oil
ICSC # 1430
CAS # 64741-97-5
RTECS # PY8041000
EC # 649-458-00-9
October 16, 2001 Validated

TYPES OF HAZARD/ EXPOSURE

ACUTE HAZARDS/ SYMPTOMS

PREVENTION

FIRST AID/
FIRE FIGHTING

FIRE Combustible.
NO open flames.
Foam, water spray, dry powder, carbon dioxide.
EXPLOSION

In case of fire: keep drums, etc., cool by spraying with water.
EXPOSURE


•INHALATION Dizziness. Headache.
Local exhaust.
Fresh air, rest. Refer for medical attention.
•SKIN Dry skin.
Protective gloves.
Remove contaminated clothes. Rinse skin with plenty of water or shower.
•EYES Redness.
Safety spectacles.
First rinse with plenty of water for several minutes (remove contact lenses if easily possible), then take to a doctor.
•INGESTION Diarrhoea. Nausea.
Do not eat, drink, or smoke during work.
Do NOT induce vomiting. Refer for medical attention. See Notes.

SPILLAGE DISPOSAL

STORAGE

PACKAGING & LABELLING

Ventilation. Collect leaking and spilled liquid in sealable containers as far as possible. Absorb remaining liquid in sand or inert absorbent and remove to safe place.
Separated from strong oxidants.

Note: H, L
T symbol
R: 45
S: 53-45
ICSC: 1430 Prepared in the context of cooperation between the International Programme on Chemical Safety & the Commission of the European Communities (C) IPCS CEC 1994. No modifications to the International version have been made except to add the OSHA PELs, NIOSH RELs and NIOSH IDLH values.

DISTILLATES, PETROLEUM, solvent-refined light naphthenic

ICSC: 1430

I

M

P

O

R

T

A

N

T


D

A

T

A

PHYSICAL STATE; APPEARANCE:
LIQUID

PHYSICAL DANGERS:


CHEMICAL DANGERS:
Reacts with strong oxidants causing fire and explosion hazard.

OCCUPATIONAL EXPOSURE LIMITS:
TLV: (oil mist, mineral) 5 mg/m3 Intended change (ACGIH 2001).


ROUTES OF EXPOSURE:
The substance can be absorbed into the body by inhalation of its aerosol and by ingestion.

INHALATION RISK:
Evaporation at 20°C is negligible; a harmful concentration of airborne particles can, however, be reached quickly when dispersed.

EFFECTS OF SHORT-TERM EXPOSURE:
The substance is irritating to the skin . If this liquid is swallowed, aspiration into the lungs may result in chemical pneumonitis.

EFFECTS OF LONG-TERM OR REPEATED EXPOSURE:
Repeated or prolonged contact with skin may cause dermatitis.

PHYSICAL
PROPERTIES

Boiling point: 150-600°C
Relative density (water = 1): about 0.84 - 0.94 at 15°C
Flash point: > 124°C
Octanol/water partition coefficient as log Pow: 3.9 - 6 (calculated)

ENVIRONMENTAL
DATA


N O T E S

A raffinate contains C15-C30 hydrocarbons with a viscosity of less than 19 cSt at 40°C (100 SUS at 100°F). It contains few normal paraffins. Depending on the raw material and the production processes, the composition and physical properties of this solvent can vary considerably. The symptoms of chemical pneumonitis do not become manifest until a few hours or even a few days have passed and they are aggravated by physical effort. Note L: the EU classification as carcinogen (R45) does not apply if it can be shown that DMSO extract (IP 346) is below 3% by volume.PY8041000 refers to mineral oil, petroleum distillate, solvent refined (mild) light naphthenic; PY8041001 refers to mineral oil, petroleum distillate, solvent refined (severe) light naphthenic.Card has been partly updated in April 2005. See section EU classification.

ADDITIONAL INFORMATION



ICSC: 1430 DISTILLATES, PETROLEUM, solvent-refined light naphthenic
(C) IPCS, CEC, 1994
IMPORTANT LEGAL NOTICE: Neither NIOSH, the CEC or the IPCS nor any person acting on behalf of NIOSH, the CEC or the IPCS is responsible for the use which might be made of this information. This card contains the collective views of the IPCS Peer Review Committee and may not reflect in all cases all the detailed requirements included in national legislation on the subject. The user should verify compliance of the cards with the relevant legislation in the country of use. The only modifications made to produce the U.S. version is inclusion of the OSHA PELs, NIOSH RELs and NIOSH IDLH values.
Top